nittanylion64 10+ year member
Member
I have been on here for a little bit and have decided to show off my attempt at such a big system. Of course critiques are wanted.
First - The components
Alpine 9855
Clif Designs 6.5 Components - PX650C - Fronts
Clif Designs 5.25 Components - PX525C - Rears
CDT EF-8 8 inch subx2
Elemental Designs EU-700 6.5 Subx2
MB Quart RWE 302 12in Subx3
Powerbass ASA 400.4
Powerbass ASA 300.2
Powerbass ASA 1000.1
2 runs of Fosgate 4 gauge wiring
Vehicle is an 03 Explorer with the Big 3 done.
This is a lot of subs. The 2 elemental 6.5 subs will be fiberglassed into the front doors and will run all the time. The 8s will be fiberglassed into the rear floor and used when I have to take the 12s out and use the Explorer for Utility stuff. The 12s will be wired at 1.3ohm and the 8s will be at 2 ohm.
First - The components
Alpine 9855
Clif Designs 6.5 Components - PX650C - Fronts
Clif Designs 5.25 Components - PX525C - Rears
CDT EF-8 8 inch subx2
Elemental Designs EU-700 6.5 Subx2
MB Quart RWE 302 12in Subx3
Powerbass ASA 400.4
Powerbass ASA 300.2
Powerbass ASA 1000.1
2 runs of Fosgate 4 gauge wiring
Vehicle is an 03 Explorer with the Big 3 done.
This is a lot of subs. The 2 elemental 6.5 subs will be fiberglassed into the front doors and will run all the time. The 8s will be fiberglassed into the rear floor and used when I have to take the 12s out and use the Explorer for Utility stuff. The 12s will be wired at 1.3ohm and the 8s will be at 2 ohm.