SOLD FS: Treo TE 15.22 & Zapco Dc reference 1100.1

  • 2
    Participant count
  • Participant list

shields
10+ year member

Member
52
0
ok
I have four dual 2 ohm fifteens. Mechanical are 10/10 and looks are 6/10 one has two scuffs on the surround hole is not all the way through (pics shown) two are 8/10 nothing visibly wrong, the fourth was only played for ten mins it was a replacement so its like new out of box. i would like to get 175 shipped each for the three better shaped ones and 150 shiped for the ones that has scuffs. will make special deal if all four are bought together pm for that.

IMG_0349.jpg


IMG_0348.jpg


IMG_0347.jpg


IMG_0346.jpg


IMG_0345.jpg


Up next is my Zapco dc reference 1100.1 it is rated at two ohms to do 1100 rms. it will run at one ohm daily with no problem. i have the symbilink for it and the computer software to tune it. It is about three months old and i have the original box. it has a few scuffs from where it was mounted under the seat but is one percent working. everyone here knows zapco quality and they do rated power plus some more. i would like to get 700 shipped.

IMG_0354.jpg


IMG_0353.jpg


IMG_0351.jpg


IMG_0352.jpg


IMG_0350.jpg


i know i dont have any references here and a low post count but i have 30+ transaction on another forum selling bows. i can link my feedback from there and also included that screen name in the pics. all the bowes were $400+ plus also i could post screen shots of the feedback.

 
Is it just me, or does the Zapco say 90a max above the mini-ANL on it and the mini-ANL says 100a on it?

Free bump, those TE's have sexy cones.

Kef

 
yes it does say that. this is the way it came out of the box from my dealer who said he had it modded for a little more power. when we clamped it at one ohm it did right above 1600 watts rms with no clipping. it played all day long and never had a hiccup at that low of impd. he is a very reliable dealer.

i love the cones and speakers but they wont fit my new build so i have to part with them.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

  • Locked
I have a treo ssx motor if that interests you at all?
1
2K
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
176
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
374
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
479
  • Locked
NVX MVPA1 Best tiny amp Installed a bunch, but have one pushing a sealed 12 @ 2ohm in my daily beater Can bump it all day long and barely gets...
4
768

About this thread

shields

10+ year member
Member
Thread starter
shields
Joined
Location
ok
Start date
Participants
Who Replied
Replies
8
Views
2,073
Last reply date
Last reply from
shields
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top