I have a RF P4004 4 channel amp for sale. I bought it used about six months ago and since then I haven't had any problems with it. Everything functions as it should. Cosmetically, one of the screws that holds the bottom chrome plate broke and is stuck in the hole. But the bottom plate still stays on it with just one screw. Also, there are some minor scuffs on the chrome plates, but nothing major.
I was using this amp to run a pair of PG RSD components on the front channels and had the rear channels bridged running a 12" Alpine Type R. I never pushed it too hard or had it overheat.
The amp does 50 watts RMS x 4 at 4 ohms (100 watts RMS x 4 at 2 ohms) or 200 watts RMS x 2 at 4 ohms (4-ohm stable in bridged mode). But these amps are known to be pretty underrated.
I'm also including the remote bass knob. I'm asking $80 shipped, paypal only. Refs are below. Post here or PM if interested.
Amp
Amp installed w/botom cover off
Bass knob
I was using this amp to run a pair of PG RSD components on the front channels and had the rear channels bridged running a 12" Alpine Type R. I never pushed it too hard or had it overheat.
The amp does 50 watts RMS x 4 at 4 ohms (100 watts RMS x 4 at 2 ohms) or 200 watts RMS x 2 at 4 ohms (4-ohm stable in bridged mode). But these amps are known to be pretty underrated.
I'm also including the remote bass knob. I'm asking $80 shipped, paypal only. Refs are below. Post here or PM if interested.
Amp
Amp installed w/botom cover off
Bass knob
