SOLD Fs:kicker Zr360 $140 Shipped!

shallowfu
10+ year member

24/7 REPAIR
This is a KICKER ZR360 2 channel amp for $140 shipped.It is great condition and works great!Comes with everything amp,2 end caps,all gold set screws,org. box,birth sheet,install info sheet,some other stuff.The birth sheet is marked 544 watts at 4 ohms.It has the ZRX Subwoofer crossover module ready for bypass,lowpass or hipass!This is a plug and play amp...//content.invisioncic.com/y282845/emoticons/crazy.gif.c13912c32de98515d3142759a824dae7.gif



 
This is a KICKER ZR360 mono channel amp for $140 shipped.It is great condition and works great!Comes with everything amp,2 end caps,all gold set screws,org. box,birth sheet,install info sheet,some other stuff.The birth sheet is marked 544 watts at 4 ohms.It has the ZRX Subwoofer crossover module ready for bypass,lowpass or hipass!This is a plug and play amp...//content.invisioncic.com/y282845/emoticons/crazy.gif.c13912c32de98515d3142759a824dae7.gif

ZR's are bridgeable 2 channel amps not mono amps lol.

I thought you made a typo of zx but when I saw the pix I realised it was a zr lol.

I'm intrested but I just got a small zed amp to play with, so when it gets here I'll play with it and decide if I need another small amp for my center channel //content.invisioncic.com/y282845/emoticons/naughty.gif.94359f346c0f1259df8038d60b41863e.gif late!

 
All measurements @ 14volts unless otherwise specified

Frequency Response (4-ohm IHF Load, 20 Hz to 20 kHz 1 kHz Ref.): +0 dB, –.8 dB

L/R channel error max deviation 20 Hz to 20 kHz: .03 dB

Phase Response (4-ohm IHF Load, 20 Hz to 20 kHz 1 kHz Ref.): +20 degrees, –43.8 degrees

Signal-to-Noise Ratio (Below Rated Output, “A” weighted): –103 dB

Distortion at Rated Output @ 1 kHz: .034% @ 400 watts

Output Power (resistive) minimum output (20 Hz to 20 kHz @ 1% THD+N, all channels driven into 4 ohms): 141.3 watts x 2 @ 14 volts; 141.1 watts x 2 @ 12.8 volts; 107.4 watts x 2 @ 10.4 volts

Output Power (resistive) minimum output (20 Hz to 20 kHz @ 1% THD+N, all channels driven into 2 ohms): 257.4 watts x 2 @ 14 volts; 244.5 watts x 2 @ 12.8 volts; 167.5 watts x 2 @ 10.5 volts

Output Power (4-ohm IHF Reactive Load @ 1% THD+N @ 60 Hz bridged): 574.2 watts

Output Power (2-ohm IHF Reactive Load @ 1% THD+N @ 60 Hz bridged): 725.4 watts

Crosstalk (Referenced to Rated Output, 20 Hz to 20 kHz): –62.4 dB

Damping Factor @ 100 Hz: 147

Voltage for Rated Output: 102 mV to 2.14 volts

Idle Current Draw: 2.3 amps

Current Draw @ 1/3 Maximum Power: 37.6 amps @ 182 watts

Efficiency @ 1/3 Maximum Power: 35%

Power-Up Noise: 10.9 dB SPL

Power-Down Noise: 11.3 dB SPL

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Yep, that will mark the third iteration of teh X series. i figured that was in the loop as they have been running out of stock on the last...
11
689
Is this a blue or blue/white wire from the Kenwood? The ACC wire is red and although that should turn on the amp, it is not the prefered wiring...
1
767
low level when using RCAs so that knob should be pushed out. The crossover turn it all the way right and use the one on the head unit and set it...
5
1K

About this thread

shallowfu

10+ year member
24/7 REPAIR
Thread starter
shallowfu
Joined
Location
WEST PALM BEACH ,FL.
Start date
Participants
Who Replied
Replies
29
Views
1,689
Last reply date
Last reply from
ramos
1000008028.jpg

Mr FaceCaser

    May 20, 2024
  • 0
  • 0
1000008027.jpg

Mr FaceCaser

    May 20, 2024
  • 0
  • 0

New threads

Top