Sold FS: 20ft Kicker Hyperflex 1/0 w/ Fuse holder

[wong05tsx 10+ year member]

SOLD

Brand new straight from the amp kit, I already hooked up the fuse holder to it.

Will be willing to trade for a ~20ft (17ft minimum) CONTINUOUS run of Kicker/Knu flex or similar 4ga + fuse holder 150A + $$$ (depending if wire is new/used/length) PM me and we can figure something out.

Otherwise, I'm asking for 60$ shipped obo [not sure what to price it @!]

I'd be more insterested in a trade.

Selling because there is no way that 0ga was going to fit thru my grommet, I have a 4ga run thru passenger side right now, so I think i'll just add another 4ga run thru driver side. My grommet is really small, i can barely fit the head of the 0ga in!.

Refs: see sig

Click to read more...

 

[theothermike 10+ year member]

i got lots of short runs of 4' 1 is 5' one is 6' one is 4', etc.. etc.... and i have a anl knukonceptz fuseholder.

also i dont think 70 will get u any hits when the whole amp kit is 87$ on ebay. for the 1/0 gauge + fuseholder + 2 distros, 2 5' 4 gauge runs etc.. etc...

mike-

 

[twisztdpunisher 10+ year member]

drill bigger? run under the car?

 

[audiobahnuser18 5,000+ posts]

hey man diffrent askn here but did u ever ship out my Rcas?

 

[wong05tsx 10+ year member]

i got lots of short runs of 4' 1 is 5' one is 6' one is 4', etc.. etc.... and i have a anl knukonceptz fuseholder.
also i dont think 70 will get u any hits when the whole amp kit is 87$ on ebay. for the 1/0 gauge + fuseholder + 2 distros, 2 5' 4 gauge runs etc.. etc...

mike-

price edited, thanks for the info.

i need a continuous run of 17ft minimum though

 

[wong05tsx 10+ year member]

drill bigger? run under the car?

I have no father figure in the house; no tools. I've got a screw driver, allen wrench, and a solder.

No ramps or anything to lift the car, and even if I did, i don't have a drill

 

[headbussaboi 10+ year member]

Did you search over at AZ.com? I thought you guys had that big rubber grommet in the center of the engine compartment? You know, the one where your factory main wires run through to the inside?

 

[wong05tsx 10+ year member]

yeah, i was trying to get it in for two hours today, no luck :\ I can push it in about 6 inchs, doesn't go anywhere after that.. I think stiffer wire would be better, might be too flexible to string it down that tight space

 

[boom*u*like*dat 10+ year member]

$50 shipped to 15845? Let me know thanks

 

[Bassballer5 10+ year member]

PM sent regarding trade

 

[boom*u*like*dat 10+ year member]

any intrest?

 

[mavster 10+ year member]

bump...sent pm

 

[shpatb 10+ year member]

i have 4 gage stinger with 150 a but its installed right now

i'd need the 0 gage put in before i take out the wiring i have right now.

 

[wong05tsx 10+ year member]

SOLD to returning customer tapout

thanks again