Fi Btl

Sure can.. Just make sure to send a clean signal. My Btl 12 takes everything my Atomic 3000.1 can dish out... I did manage to make my dustcap seperate once! ha ha ha //content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif Subs is still working fine and running like a champ! Never gets stinky even when i run it full tilt for extended periods of time.

 
Is 3000 watts close to too much power for a BTL or is it still relatively safe from blowing? In a daily setup.

watch your gains //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 
All right good that's what I'm looking to hear, anyone else have an opinion to share with me. Want to get a Sundown 3000D sometime in the next year and I'm tryin to figure out what I'm going to send all of that power to. Hopefully I don't **** up or I'll be out a good bit of money

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Alpineforever

10+ year member
CarAudio.com Elite
Thread starter
Alpineforever
Joined
Location
Austin TX
Start date
Participants
Who Replied
Replies
8
Views
633
Last reply date
Last reply from
denim
IMG_20260515_202650612_HDR.jpg

sherbanater

    May 15, 2026
  • 0
  • 0
IMG_20260515_202732887_HDR.jpg

sherbanater

    May 15, 2026
  • 0
  • 0

New threads

Top