Sold F/S Visionik 900HC 3KW @ 1ohm Monster Class A/B Amp 28 inches long! /cheap!

ampjunkielikeme
10+ year member

CarAudio.com Veteran
Rating: 100%
7 0 0
235.00 firm shipped for each amp to the cont usa....

470.00 shipped for both amps

that covers paypal fees, shipping cost , bubble wrap, box, and insurance...

i have 2 of these amps get 5000+ watts for cheap

this is a visionik 900hc. a very rare and huge class a/b amplifier...i replaced the ugly top with a brand new plexi one with vent holes for the fan....it makes the amp look just sick..IMHO //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif it is begging for a white led mounted under each of the fans...lol...maybe not...

im not sure if this amp was made in the usa or overseas?? probably korea?? , but the layout reminds me of a old school US AMPS 2000X ..

the amp has 20 power supply transistors, and 32 outputs...//content.invisioncic.com/y282845/emoticons/eek.gif.771b7a90cf45cabdc554ff1121c21c4a.gif

from a scale from 1 to 10...i would give the amp a 8.5 for condition...it has a few scuffs , but the plexi is slick as glass...

Its a MONSTER ! the amp is 28 inches from end to end!

functionality . it is a 10 out of a 10...it works 100%

f.y.i. - this amp has had the power supply rebuilt by me with new power supply transistors, new gate drivers, new gate resistors, new 949tl pwm ic chip.2 output drivers...

i load tested for a couple hours today hooked up to my 12's. they really, really, begged for mercy.. , it is ready to pound your subs ...i would not sell it if it didnt work right...

i think the amp will put out 2000+ watts....its built with very high voltage/amperage parts that are very expensive..., as long as you have a good electrical to back this monster , this amp will do some serious damage to your car, your subs and your hearing..

you can run this amp on your mids and tweets if you really wanted (has built in high pass crossover)...lol...imagine 2000+ clean watts going to 8 sets of components.. mind blowing....

specs:

2 x 750W Rms @ 4 Ohm Stereo

2 x 1000W Rms @ 2 Ohm Stereo

2 x 1500W Rms @ 1 Ohm Stereo

2 x 2000W Rms @ ½ Ohm Stereo

1 x 3200W Rms @ 1 Ohm Bridged

Fuse: 5 x 40A

http://ampguts.realmofexcursion.com/Visonik_V900HC/

it reminds of this ma amp to...this amp does the rated power is says it does also:eek:...

http://ampguts.realmofexcursion.com/MA_5082HX/

ppi572.jpg


ppi573.jpg


ppi574.jpg


ppi575.jpg


ppi576.jpg


ppi577.jpg


ppi578.jpg


This amplifier has been tested on the bench to operate normally but there is NO FURTHER WARRANTY IMPLIED OR EXPRESSED beyond that this amp will work 100% when you receive it....

 
lol...ive got a new friend that owns a car audio shop... i can get the hook up on some subs....

they might be some hifonics brutus 12's...he has loads of them... and they are cheap...

sounds easy, but the dually isnt anywhere near ready to have a system in it...

the whole body has to come off to do the stock floor body drop, then a 4 link and monster notch...and bags all around..

.

on top of that, i was wanting to run the xxv sampson on about 4 of those premier 12 inch spl subs i got from retroaudio on here......decisions...decisions.....lmao

 
No lie, in the next day or so, if you still have one I'm most likely going to get one from you. Exactly what I need for my mids n highs //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 
No lie, in the next day or so, if you still have one I'm most likely going to get one from you. Exactly what I need for my mids n highs //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif


haha....thats what im talking about.....//content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif 2000+ watts of mids and tweets.....your ears are going to bleed.//content.invisioncic.com/y282845/emoticons/eek.gif.771b7a90cf45cabdc554ff1121c21c4a.gif

 
haha....thats what im talking about.....//content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif 2000+ watts of mids and tweets.....your ears are going to bleed.//content.invisioncic.com/y282845/emoticons/eek.gif.771b7a90cf45cabdc554ff1121c21c4a.gif
already have about 1000w on em, so it'll be around 3K //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif
 
the other amp similar to this one can bridge at multiple impendaces is it not stable for this one?

1 x 1400W @ 4 ohms bridge

1 x 2400W @ 2 ohms bridge

1 x 4000W @ 1 ohm bridge

2 x 1500W Rms @ 1 Ohm Stereo

2 x 2000W Rms @ ½ Ohm Stereo

1 x 3200W Rms @ 1 Ohm Bridged

 
yes, you can bridge this visonik amp at whatever ohm you want , as long as its not .5ohm

the other amp is just showing how many watts it would put out at each ohm load " 1ohm, 2ohm, 4ohm..."

it would work the same for the visonik amp, it just doesnt list the wattage like the ma does...

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

ampjunkielikeme

10+ year member
CarAudio.com Veteran
Thread starter
ampjunkielikeme
Joined
Location
nash, tn
Start date
Participants
Who Replied
Replies
49
Views
2,718
Last reply date
Last reply from
ampjunkielikeme
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top