Engine Bay corrosion

  • 2
    Participant count
  • Participant list

Jam1e
10+ year member

Member
124
0
Green Bay
Hey everyone, I just installed my Big 3 in my Scion TC and I was wondering if the copper lugs that I used on my battery and for grounds will be alright and not corrode. Same goes for my chassis ground wire. I sanded it to get clean metal but over time I'm sure it will rust. What can I do to prevent this? I heard about using dielectric grease on it but I would just like some second opinions. Thanks!

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Hello!I'm in France and I can't register on Hifiengine for unknown reasons and i need to download the service manuals for Blaupunkt Baden Baden...
0
916
Then I don't really seen the need to run a ground directly from the alt, but given your situation, it can't hurt.
24
3K
I would run another ground wire to cleaned off metal. Sometimes there is a Metal Bracket under the dash that generally work well. You can try...
3
1K
Sounds like a ground loop, especially with the hokey ground. I'd ground to the body, do the big three. Run a ground from the radio to the amp's...
3
1K
Nice looking RCAs. Most vehicles these days have quite a bit of wiring to go back to the vehicle lighting ect that run along the bottom door...
15
3K

About this thread

Jam1e

10+ year member
Member
Thread starter
Jam1e
Joined
Location
Green Bay
Start date
Participants
Who Replied
Replies
1
Views
469
Last reply date
Last reply from
CrossoverOre
1717274743729.png

Doxquzme

    Jun 1, 2024
  • 0
  • 0
Screenshot_20240531-022053.png

1aespinoza

    May 31, 2024
  • 0
  • 0

New threads

Top