dvc wiring question

[Mercureie 10+ year member]

ive got a 2-channel amp, that is 150x2 and bridgable. im tryin to wire a type-r dual 4 ohm, with 300 rms (im assuming 150/coil). if i wired the vc in series then bridged the amp would i still get the most power w/o fryin my amp? i don't think it could handle a 2 ohm mono load.

Click to read more...

 

[MikeofTulsa Moderator]

well what is your amp stable to?

 

[Mercureie 10+ year member]

2 ohms per channel

 

[MikeofTulsa Moderator]

can you give us a bit more......so its 2ohm sterio stable.....how much power does it put out in sterio and what is it stable to mono??? you said is was bridgable right???

 

[Mercureie 10+ year member]

yea its bridgable, it puts out 150x2 rms in stereo, and 4 ohm mono stable

 

[Mercureie 10+ year member]

would i need a separate terminal out of the box if i wired the vc straight to the channels of the amp?

 

[MikeofTulsa Moderator]

if im not mistaken jus wire it w/ 2 of them and it should produce a 4ohm load....jus run the red and the black one on to the other sub and cancel the other vc like that one shows as well.....somoene else back me up on this one please