hey guys i need to know if i bridged my amp right. the amp is a memphis belle 1300 5 channel and i wanted to bridge the 4 full range channels to 2 channels to run my front componet set so this is what i did. i put the speaker wires to the correct terminals like it says to bridge the amp but the problem im haveing is if i put the rca's correctly. i called memphis and this is what the tech said to do.
get 2 y spliters with 1 female and 2 male plugs so i pluged the left side of the rca in to the y and that gave me 2 male rca's for the left side and i pluged those in the the front channels of the amp then i did the same for the right side and i only used the front rca's from my hu. when i try to mess with the fade and balance it will go left and right and when i fade it to the rear the sound goes away but is fine when its faded in the middle or to the front.
did i do it right?
it sounds really good and im happy with it i just dont want to have my amp wired wrong. the comps are mb quart premiums 6.5 with the wide sphere tweets. thanks for the help in advance guys.
