dd3510 vs fi btl10

//content.invisioncic.com/y282845/emoticons/word.gif.64b12e39f936af3b4fff38a1c0bd0244.gif
I have got to get up into the 45 region.

41 is just to low...and I pm'd doug about the 20's...he seemed more than happy to let them go.

You're a team mate...it was the only way he could sell them //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

 
sounds like the btls are like the seleniums...
No....dont get that idea at all...

The 10" cone geometry just sucks with the 12 spoke basket...

They sound fine...the cone will just slam into the spider landing basket...and there's no point in doing that //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif.

The only way you can get it to not slam into the basket is if you use a 2 slug version of the BTL and a short flatwire coil...but that design is made to peak in like a CRX...

BTL's can sound very good...its just a matter of the install at hand, tuning, vent area etc etc etc.

 
Good luck man. At a show last week I saw a trunk car do like a 152.xx on a burp, and thats honestly the loudest trunk car I have seen. I was pretty amazed by it. They are just so hard to get loud, even If you seal off the trunk area, just like trying to get 2 15's loud in a suburban, to much air to pressurize.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

12sec50 stang

10+ year member
Senior VIP Member
Thread starter
12sec50 stang
Joined
Location
baton rouge, LA
Start date
Participants
Who Replied
Replies
62
Views
2,945
Last reply date
Last reply from
SATX210
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top