big 3 in 4ga?

[kr15 5,000+ posts]

I know its not optimal, but I have some extra stinger 4ga laying around. Would it even be worth it to do it in 4ga, or is it a waste of time. Or is it one of those things where any upgrade is better than nothing?

Equipment is in my sig...Thanks

Click to read more...

 

[ltr450racer690 10+ year member]

its better than nothing imo, but i do it right the first time

 

[I Like Waffle]

If its nice 4g it can flow quite a bit of current. IE Rockford 4g can flow 125@ in a 20ft run. The shorter the run, the more current it can flow.

 

[kmanian 5,000+ posts]

hell you are going what 5ft max? it is fine.

 

[CJL 10+ year member]

x2,better than stock

 

[kr15 5,000+ posts]

Its stinger, its no where near as thick as my memphis 4ga is. And its actually less than a 5ft run. I guess its better than nothing. I am only running maybe 1000-1200rms

 

[kmanian 5,000+ posts]

Its stinger, its no where near as thick as my memphis 4ga is. And its actually less than a 5ft run. I guess its better than nothing. I am only running maybe 1000-1200rms

your good

 

[kr15 5,000+ posts]

thanks for the timely responses guys

 

[kr15 5,000+ posts]

Ok, so I was out there today to try and get this done, and I have 2 questions

1. The stock power wire goes to the starter first. So just leave that as is and run the new wire straight to the alt?

2. On my alt, I found the little rubber boot. When i pulled it down, there was 2 wires in there (I assume +/-). Is this the right location?

Thank you