ATTENTION: Mr. nG

[craigzter 10+ year member]

Need you to clear your pm's pleeese...I gots a question fooorr youuuu!!

please and thank you..(mods can delete if needed, after I talk to ngsm.)

Click to read more...

 

[craigzter 10+ year member]

and for everyone else...

was wondering if you could help me out with reconing this sdc2.5 15. Alright I took out the softparts and am preparing it for a recone. Where the Spiders are located is a ring ontop of them that contain 6 allen head screws. Ok I took them out and now how do I get the ring off to clean up the rest of the spider material left.

need help!!

 

[Mc_Hammer 10+ year member]

flat screw driver to pry it off...

 

[craigzter 10+ year member]

i done tried that...it started to crack:crap:

 

[lilmaniac2 5,000+ posts]

hammer and chisel

or a grinder,

 

[Mc_Hammer 10+ year member]

a new ring is attached to the spiders on the recone kit... break it off and throw it away

 

[Mc_Hammer 10+ year member]

hammer and chisel
or a grinder,

better have an oxygen supply if your gonna grind(melt) thru that much plastic //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

 

[craigzter 10+ year member]

alrighty...back to work I go then...may be back with more q's...but hope not

 

[craigzter 10+ year member]

better have an oxygen supply if your gonna grind(melt) thru that much plastic //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

lol...havent got access to one...altho I do have a dremel tool, but where? idk lol....

will go the hammer and chisel route.

 

[Mc_Hammer 10+ year member]

alrighty...back to work I go then...may be back with more q's...but hope not

lol, just pry it off and if you need any more help feel free to shoot me a pm... ive reconed about 10 of these

 

[craigzter 10+ year member]

Alrighty will do!!