AQ2200D @ 0.6DCR capable?

[shizzzon 10+ year member]

This might be impossible to answer unless but i'll try anyways.

I might have a final load of 1.2 ohms wired to a strapped pair of AQ2200ds.

IF i did, is that was too risky to assume rise would carry it over 2ohms at all times for DAILY only?

If it is too risky, i wont do it.

Click to read more...

 

[DBDRAGGUY 10+ year member]

For everyday musical use I would say you would be fine. This amp has a multiple protection ,if you are sending it into protect up it over 2 ohms.

 

[shizzzon 10+ year member]

can't, it would be 3 D2s wired in series\parallel. Final DCR load is 1.2.

I don't wanna buy them just to find out hey... there's no other way for me to wire these...

Does having a very good electrical help prevent it going into protect?

I'll have 3 HC1400s for right now, then gettin a 300a alt in a couple weeks after that.

 

[DBDRAGGUY 10+ year member]

I have only sent mine into protect 1 time, and that was when I threw the spider off the basket and tore the tinsel leads. I have wired a pair strapped down to 0.6ohms for burps and they dont seem to mind it. In my experience with these amps you would be good to go at 1.2 ohms daily. I Bass Race with mine strapped at 1ohm and have never had an issue.

 

[Kold_Killa 10+ year member]

After impedance rise I wouldn't think there would even be a problem....