I have reached the boiling point; I am tired of running this pile of crap prefab box. I am ready to start a box build. I have all of the tools required to do a somewhat complex box but I do not have the knowhow when it comes to design. That’s where one of you comes into the equation. I am willing to purchase a nice box design from someone who can provide a nice detailed drawing that will allow me to build this without too many issues.
Here is what I am working with and trying to accomplish.
I want to run a single 10 or 12, I currently have a 10" powerbass xtreme(the older version) but would like to upgrade to a 12" AQ hdc3. I can cut the whole for the 10" temporarily than make it bigger once the 12 arrives.
For amplification I am running a ed nine.1, will be running at 1 ohm for an output of 1200 watts. I cannot run at .5 because I do not have the electrical.
I am mainly looking for a sq set up but would like it to be capable of decent loudness. I’m sure you can recommend a decent tuning point to accomplish this.
I have limited space to work with, the back of the box will have to be slanted because of the seat. I cannot extend to far into the trunk because I need as much space as possible (I have a kid) and with the dimensions listed below it will fit right in. Here are the dimensions I was thinking.
Top depth: 9"
Bottom depth: 13"
Width 36"
Height: 13"
Give me any suggestions and a price for the design. I am looking forward to the build and will definitely post a build log!
Here is what I am working with and trying to accomplish.
I want to run a single 10 or 12, I currently have a 10" powerbass xtreme(the older version) but would like to upgrade to a 12" AQ hdc3. I can cut the whole for the 10" temporarily than make it bigger once the 12 arrives.
For amplification I am running a ed nine.1, will be running at 1 ohm for an output of 1200 watts. I cannot run at .5 because I do not have the electrical.
I am mainly looking for a sq set up but would like it to be capable of decent loudness. I’m sure you can recommend a decent tuning point to accomplish this.
I have limited space to work with, the back of the box will have to be slanted because of the seat. I cannot extend to far into the trunk because I need as much space as possible (I have a kid) and with the dimensions listed below it will fit right in. Here are the dimensions I was thinking.
Top depth: 9"
Bottom depth: 13"
Width 36"
Height: 13"
Give me any suggestions and a price for the design. I am looking forward to the build and will definitely post a build log!
