blackstar602 10+ year member
Junior Member
I have a 10" alpine type-R i havnt used, this is new in box and has never been used just taken out to verify contents. Im Asking $100 Shipped
SWR-1042d
Details:
* 10" subwoofer with dual 4-ohm voice coils
* Kevlar reinforced pulp cone with Santoprene™ rubber surround
* cast aluminum frame with perimeter venting
* frequency response: 26-600 Hz
* power handling: 200-500 watts RMS (250 watts per coil)
* peak power: 1,500 watts
* sensitivity: 83 dB
* top-mount depth: 6-7/8"
Also here is an Alpine MRP-M450 mono amp for the sub. little scuffs but no damage
$125 shipped
Details:
* mono subwoofer car amplifier
* 220 watts RMS x 1 at 4 ohms (400 watts RMS x 1 at 2 ohms)
* variable low-pass filter (50-200 Hz, 24 dB/octave)
* tuned Bass EQ (0-12 dB bass boost at 50 Hz)
* subsonic filter (15 Hz, 24 dB/octave)
* MOSFET power supply
* CEA-2006 compliant
* STAR Topology (minimizes internal noise and prevents ground interference)
* speaker- and preamp-level inputs
* gold-plated screw terminals
* fuse rating: 20A x 2
* 8-gauge power and ground leads recommended — wiring and hardware not included with amplifier
* 9-3/4"W x 2-7/16"H x 9-9/16"D
SWR-1042d
Details:
* 10" subwoofer with dual 4-ohm voice coils
* Kevlar reinforced pulp cone with Santoprene™ rubber surround
* cast aluminum frame with perimeter venting
* frequency response: 26-600 Hz
* power handling: 200-500 watts RMS (250 watts per coil)
* peak power: 1,500 watts
* sensitivity: 83 dB
* top-mount depth: 6-7/8"
Also here is an Alpine MRP-M450 mono amp for the sub. little scuffs but no damage
$125 shipped
Details:
* mono subwoofer car amplifier
* 220 watts RMS x 1 at 4 ohms (400 watts RMS x 1 at 2 ohms)
* variable low-pass filter (50-200 Hz, 24 dB/octave)
* tuned Bass EQ (0-12 dB bass boost at 50 Hz)
* subsonic filter (15 Hz, 24 dB/octave)
* MOSFET power supply
* CEA-2006 compliant
* STAR Topology (minimizes internal noise and prevents ground interference)
* speaker- and preamp-level inputs
* gold-plated screw terminals
* fuse rating: 20A x 2
* 8-gauge power and ground leads recommended — wiring and hardware not included with amplifier
* 9-3/4"W x 2-7/16"H x 9-9/16"D