4ohm DVC wiring question

[Ganglyminnow 10+ year member]

2 subwoofers:

http://www.cardomain.com/item/PIOTSW306DVC

Amp:

http://www.crutchfield.com/S-d60Au3DnpCV/cgi-bin/prodview.asp?i=049RAA1000&g=130&search=mb+quart&SearchDisplay=MB+Quart

I'm having some trouble getting these things to hit like I know they should, and I think it may be because of wiring, but i'm not sure...

The subs are in separate chambers. On each sub I wired each coil + to + & - to -next running a wire from one + and one - in each chamber to its corresponding terminal. Lastly I attatched a wire to each of the outside post terminals on both sides and connected them to 2 sets of+ & - inputs.

Shouldn't this show a 1ohm load? What am I doing wrog here?

*confused* //content.invisioncic.com/y282845/emoticons/uhoh.gif.c07307dd22ee7e63e22fc8e9c614d1fd.gif

Click to read more...

 

[cjjackson85 5,000+ posts]

Do it like so, then they will boom like so, assuming your gains are set per the tutorial...

 

[Ganglyminnow 10+ year member]

ok, but these subs are in separate chambers; am I supposed to run wires outside of the box to connect the subs??

 

[cjjackson85 5,000+ posts]

Drill a hole through the partition, is easier...

 

[Raffi 10+ year member]

//content.invisioncic.com/y282845/emoticons/handclap.gif.0c301076f534e244f0460706894f19e0.gif//content.invisioncic.com/y282845/emoticons/iagree.gif.15d6c075ee8d3913ba26866d06993068.gif//content.invisioncic.com/y282845/emoticons/woot.gif.aaa6090e619a97b6090d16dd863c5a69.gif//content.invisioncic.com/y282845/emoticons/peace.gif.2db28b618ed8d1964ebbe2f5021d2c39.gif

1ohm Will make them POUND!