2 12 Mtx terminators and 1000 watt pioneer amp 2 channel

[KarRamRod1999]

Hi , I was wondering how to go about tuning my amp to get the best performance from it because it’s getting hot and cutting out on me

Click to read more...

 

[Jimi77 Premium Member]

Turn it down. Do you have the correct load to the amp (probably 2 ohm per channel or 4 ohm bridged).

thesuicidaleggroll.com - thesuicidaleggroll Resources and Information.

thesuicidaleggroll.com is your first and best source for all of the information you’re looking for. From general topics to more of what you would expect to find here, thesuicidaleggroll.com has it all. We hope you find what you are searching for!

www.thesuicidaleggroll.com

 

[KarRamRod1999]

Turn it down. Do you have the correct load to the amp (probably 2 ohm per channel or 4 ohm bridged).

thesuicidaleggroll.com - thesuicidaleggroll Resources and Information.

thesuicidaleggroll.com is your first and best source for all of the information you’re looking for. From general topics to more of what you would expect to find here, thesuicidaleggroll.com has it all. We hope you find what you are searching for!

www.thesuicidaleggroll.com

I have it bridged , it’s a 2 channel amp my hu is a pioneer dehx6500bt

 

[dragon.breath 10+ year member]

Your 2 channel amplifier can only handle 4 ohms or higher when bridged.
Sounds like that you have wired the subwoofers below 4 ohms.

Subwoofer wiring diagrams — how to hook up your subs

How to hook up your subs for powerful bass

www.crutchfield.com

 

[audiobaun 5,000+ posts]

You can wire those subs up @8 ohms if they are both SVC4 ohm subs,and that amp will run fine after being tuned properly

Subwoofer Wiring Diagrams for Two 4 Ohm Single Voice Coil Speakers

www.the12volt.com