None that show it any better. A bunch of them when I cut the top off and reworked the port. I followed Alpines recommendation of a 3" port and had a lot of port noise. I cut the old port out and put a 4" in there to replace it. Worked well and the noise is gone.
I should have taken build picts. It was my first time using fiberglass too. The front is 2 pieces of 3/4 MDF and I used a belt sander to get the slight radius. The top, sides and some of the back are 3/4 MDF also. It looks like a double baffle but its just a 14" square piece of MDF under the sub so I could sink it down and make it flush.
When I get home I could snap a pict of how it looks with the seat in.
I should have taken build picts. It was my first time using fiberglass too. The front is 2 pieces of 3/4 MDF and I used a belt sander to get the slight radius. The top, sides and some of the back are 3/4 MDF also. It looks like a double baffle but its just a 14" square piece of MDF under the sub so I could sink it down and make it flush.
When I get home I could snap a pict of how it looks with the seat in.
