Sold 12" JL W7 Motor for cheap

[joe98chevy 10+ year member]

Item(s) for Sale:

12" JL W7 Motor

Item(s) Description/Condition:

used...cosmetically 7.5-8/10

really small chips on bottom slug

3" coil

Price: 80 shipped if using usps (fits in a large flat rate box but pole piece barely clears box when closed by half an inch fyi

Shipping and Miscellaneous Item Information:

Item Pictures:

(List pictures in this section, 1st picture should be your username/date if you have less than 10 positive feedbacks with the i-Trader system or less than 10 references that you have sold to in the past. (These must be listed in your signature, or a link provided to a feedback thread listing these references)).

Click to read more...

 

[Phoenix Risen 10+ year member]

do those have a special bolt patter or will a standard basket fit with out having to be re-drilled

 

[Spooney 10+ year member]

Not 100 percent sure but I believe they have to be re-drilled.

 

[joe98chevy 10+ year member]

yes either the top plate or basket would have to be redrilled. as you can see i still have all the screws in case you were to redrill the basket.

i was going to have splaudio build a sub for me using this motor but work has been slow so im not planning to spend anymore monies on this at the time.

 

[Ge_off_me 5,000+ posts]

I know that these have a super super tight gap and psi said that they won't recone them anymore.

 

[joe98chevy 10+ year member]

I know that these have a super super tight gap and psi said that they won't recone them anymore.

yea thats true. splaudio would though, he does good work. i really wanted to get a 10'' built but moneys tight right now.

 

[Ge_off_me 5,000+ posts]

Splaudio does great work indeed!

 

[ldyzlvudis06 10+ year member]

sorry to threadjack a tad bit, but who/what is this Splaudio? im looking to see if i can get something built using a W7 motor that i have also

GLWS

 

[Ge_off_me 5,000+ posts]

That is his username. He is a great sub builder, here is a link to his work thread.

http://www.caraudio.com/forums/subwoofers/492473-splaudios-custom-subs-thread.html

 

[huricaine 10+ year member]

You haz a W7 motor? glws...

 

[nu2spl 10+ year member]

do you know the gap dimensions?

 

[joe98chevy 10+ year member]

do you know the gap dimensions?

the caliper i have is not the best but here is what i got

2.972 id

3.204 od

 

[resko1 10+ year member]

I actually have the original S3 ohm coils for these and can get more. Anyone interested i will recone W7's.

 

[huricaine 10+ year member]

Howd you get orig coils resko1?

 

[nu2spl 10+ year member]

i bet a 4 layer coil from sundown will fit, the 8 layer coil that i have is 3.010 ID and 3.257 OD