amp 4 channel

Product Brand & Model: I have a Mosconi D2 100.4 DSP amplifier and Controller for sale. It's 4 channel amplifier with a built in DSP. Condition of all items: In full working order 8 out of 10 Total Price: : price is as follows; DSP only $380 shipped to USA DSP & Controller $440 USD...

For a 4 channel amplifier 70w RMS 170w peak power (Sony XMN1004) -Does the amplifiers peak power need to be higher the same or lower than the peak power rating of the speakers -If I use two sets of speakers 1 more powerful 1 less powerful, can power be favoured relative to the speaker power or...

Nearly new Rockford P400x4. My son had it in his Audi, then realized that his old man was right. He needed more power to run his system. Was used for literally 1 week. Installed it on a Saturday and replaced it the following Saturday. Comes with original box, birth certificate and spec sheet. I...

Would it be my amp is dying? Ive had it for 4 years (machete 80.4) The speakers buzz at any volume, any mode (AM/FM bluetooth, USB) I have done the big 3 upgrade. All wires are OFC wire from amps to speakers. The sub is just fine but all channels off the 4channel amp buzz. Heres the kicker and...

I've done a few little projects in various rigs but I wanna spend some big bucks on my jeep. I mainly am here just to make sure this setup will come together nicely. What better place for reinsurance than here! Here's what I'm trying to do.. I currently have 2 12" 2400 skar audio subs from a...

Hello all, I am aware that this is an out of ordinary post for this forum, but any advice would be greatly appreciated. I am building a custom, Raspberry Pi (small single board computer) based head unit for my 2005 Ford F-150. It will run a custom software called OpenAuto Pro, and outputs...

Recently got some cheap aftermarket speakers and am seeings 100RMS for my 6.5 & 45RMS for the 6x9. What would be the perfect amp to power just the 4 speaker amp alone? I don’t want to get a sub so I wouldn’t want a big ol amp that would just be overkill and not being used. Also am I pairing my...

I have a KICKER - CX 360W Class AB Bridgeable Multichannel Amplifier with Variable Crossovers KICKER - CS Series 6" x 9" 3-Way Car Speakers with Polypropylene Cones 4 Ohms in the rear Kenwood - 6-1/2" 2-Way Car Speakers with Polypropylene Cones 4 Ohm in the doors and it was wired by Best...

Hey fellow car audio guys, I'm gonna be making my own speaker box for a Sundown X8, I'm gonna use 3/4 MDF, my question is; What saws will I need to make it? I have a table, and circular saw, but I'm a little confused on how to cut out the hole, jig saw? What saws do you guys use on sub...