Recent content by yokosgs

Thank you

I want to run 2 channels on my gt42 to highs and was wondering if I could bridge the other 2 channels down to a1 ohm load without hurting it If not that's ok, just wondering if I could get a hair more power to the sub Thanks!

I've searched but can't figure a good answer... Have a 99 silverado extended cab, and don't want anything super loud just clean sounding, have a vision gt 42 in going to power my front focals with and want to bridge the rear channel for a sub (350 rms ) I have no experience building a ported...

Hi looking for a sundown sd2 10 or an e10 , need dual 4 Would even like an id or idq 4 ohm 10 if I can find one Thanks!

payment sent thank you

pm sent!

49!

pm sent

im not sure i havent run it yet running it off of a diamind d6 1200.1 but only at 2 0hms so it will be seeing 800 rms

hi guys , i have an re se 12 and am going sealed , since i dont wont anymore weight than im already getting my question is can i go a little bigger than the recommended 1 cubic foot? will i see any gains by doing this thanks!

build a skeleton of the area i want glassed with peaks and reinforcment for the look i want, i like to use fleece to get the shape , resin that 50 grit grind then fiberglass mesh more resin and repeat, grind then duraglass in spots need, evercoat rage to even out the surface , 80 then 150 from...

sorry i must do mine different since i use techniques i use at work in the bodyshop

cant seem to find them on there site

thank you!

hi lookin for a 1/0 and a 4awg kompression fitting for my knukonceptz distro block just wondering if anyone up here has any extras thanks