Recent content by Yaris

Hi, i'm going to run two subwoofers : 1- JBL GTI 12", rated 700 RMS 2- Punch HX2 15", rated 600 RMS with jbl bpx2200.1 amp can i use 10 farad rockford fosgate digital cap with stock battery / alt instead of dual batteries system ? btw: i'm using normal battery because deep cycle batteries...

Amplifiers is not only about how much power they can push, but also it's all about pushing a loud beautiful sound !! I would recommend Rockford Fosgate amplifier over anything. if you have the purchasing power then go for RF (i recommend power series), otherwise seek for a cheaper one

for sure the guy who installed this system won't notice any difference in sound quality because he didn't use to hear it on daily basis, unlike you you used to hear your sound system a lot that's why you are the only one who would be able to notice any differences in sound quality even if it's...

i don't have voltmeter so i don't think that i would be able to measure 45 volts !! is there any other way for measuring this ? and yes the amp is getting hot, specially in the morning because it's 43 C here !!

Thank you, you support is really appreiciated my problem has been solved after replacing the following : 1- replacing the small ground wire with one same size as power cable (16mm thickness) 2- connecting the power cable directly to the + at the battery (in the previous setup i was connecting...

okay i'll replace the 6mm thickness wire which used for the grund cabales with a 16mm thickness one to be as size as the power cable or do you recommend to add another ground (16mm) to the current one (6mm) to be total (22mm), would there any problem if the power / ground cables are not same...

you can't bridge 2 amplifiers together. you can wire each sub itself 2 ohm, then connect each one with it's amplifier. but it's better to run one amp rather than 2 amps, also it's better to wire the 2 subs together rather than wiring each one itself you want to wire the two subs together...

so, do you think it's because of the difference in wire size between power & ground cables ? the gain has to be set between 0-12, i had it at 3 bass boost = 0db frequency = 50Hz

Hi guys, i have 15" Alpine type r with Kicker 06zx1000.1 wired 2 ohm Power wire is 0000 gauge (16mm thickness wire) Ground wire is 00 gauge (6mm thickness wire) Head unit (Pioneer DEH-P8850) with High output 5v when i turn the volume up the subwoofer cut off on the hard hits also the main...

Hi guys, I have alpine SWS-12D4, 1500 watt max power 500 watt rms can i install this subwoofer to 4 channel amp ? i mean how can i install one subwoofer to 4 channel amp so that i take the full amp power !! i'll use either kenwood KAC-7405 amp or Kenwood KAC-8405 amp both 720 watt max power...