Recent content by y22kc

This is a great write up. I bought a 980p deck off ebay that was supposed to be like new, but had the blown pico fuse noise. I've been hooking up car stereo stuff since around 1992, so I'm assuming it wasn't anything I did. Anyways, I wrapped it a different way around the rcas that ended up...

Just plugged in the numbers on bassbox6 pro, it says that it's tuned to 48hz, too high for what i'm looking for.

Yeah, it came with the manual, but that doesn't seem right to me. Most everyone else says the same, seems too small.

Bassbox 6 pro says it would be 35hz or so. Depends on the wood being 3/4 in thick and displacement of the speaker

Hello everyone, I have a Premier TS-W3001D2 sub I'm going to build a vented enclosure for. Using BassBox 6 Pro, I planned on building a 2.225 ft^3 box tuned to 33hz. I've got the flared port from partsexpress that is 4" in diameter. Bassbox says the port length should be 11.26 in. WinISD...

As cheap as I can, lol. I've seen these amps at a few places that are in my price range. These should be way better than the amps I have now, correct?

No, the xover has 2 inputs. I would take say the left channel and run it to one input, then parallel it over to the other input. I was curious if this would make the amp see a 2 ohm load if I did it like this.

Hello all, looking for a little advice on some system changes I'm planning for my 1995 Mustang. First of all, I currently have a Premier deh-p980bt deck, Infinity 5x7 2 ways in the door, some old kicker impulse 5x7 2 ways in the rear deck. They are powered by an old Rockford Fosgate 300x...