Recent content by xromarx

Yes both subs are wired at 2ohms. atleast that’s how it came with. i have the mtx terminator dual subs if you want to look more into it. As for the gains, I did use a volt meter to set it. so it should be where it’s at.

Hey I noticed you run a Kenwood as well. does yours run cool? okay so I would hope my ground is good. I bought sandpaper and sanded it down pretty well. I’m running 4 Jbl gx602 2.3ohm speakers and two 2ohm mtx terminator subs. Each speaker is 60watt rms and subs are 200watts rms each totaling...

Guys, I have a dilemma here. So I bought a cheap 6 gauge scosche wiring kit from walmart and ran it to my Kenwood x801-5 amplifier. Now I dont know if this amp, being a class D amp, normally just runs hot or it’s caused by the wiring kit. I’m asking because I’ve checked the wire when the amp is...

Hey guys so I returned my headunit and exchanged it for a pioneer AVH-1330NEX which just came out a couple months ago so it’s packed with features, it’s also 4volts preamp with a left and right sub rca output. This is all in all better! I’m acually able to reach the 31 volts now that I needed...

Alright so just for temporary use. I turned my gain down and set the bass boost up to about 3+ which gave me the 31v I needed. Is there anything in particular why I shouldn’t do this? Only reason I did this is because I really don’t want to turn my gain all the way up, which is why I think my...

Okay, I will upgrade to a thicker wire then. Hopefully it fixes the problem

I know about wires melting due to thin wire and could possibly cause a fire hazard. Howver would this be the sole reason why I’m not able to get 31volts by adjusting the gain? Hypotethically speaking, If I were to change the wire to a thicker wire lets say a 4 or 2 gauge and does not change the...

I forgot the website I found it at but unless this has an effect on achieving desired results then I can definitely change it to a thicker power wire.

Hi Kush and thanks for your reply. The tone im using is 50Hz. The subwoofer level on the headunit is set at 0. However, when I set it to max on the HU I can most definitely achieve the 31v needed. Yes I am measuring using AC Volts on the terminals with no speakers attached. My max volume is 50...

Hey guys, I decided to become a member of the this site to hopefully get some advice. I’ll list my setup first. Head Unit: Sony XAV-AX100 Subwoofer: MTX Terminator Dual 12” - 2Ohms 400 Watt RMS Speakers: 4x JBL GX602 60Watt RMS @ 2.3 Ohms each Amp: Kenwood x801 5 channel 75Watt RMS x 4 @...