Recent content by Xinspaly

you single handedly talked me into trading my entire system for an FI BTL 18, and restarting from the ground up, building the box inside my 94 cutlass ciera (same trunk setup practically.. (crossbars and all) and after reading through ALL 12 pages.. I have some questions: For a newbie, just how...

Just re-researched the big 3.. I can easily do that.. however, I feel like pulling out my headunit is even an issue. As far as im aware this is what I'd have to do to get the amp installed: 1. Rca's from HU to new amp. 2. Split the power wire from the sub amp into the sub amp and speaker amp...

Lack of knowledge.. Lest i mess something up..plus i know the guy so he will do it for real cheap.. unless its really just not that hard for a COMPLETE noob to electrical installing

So say i have my car audio peeps do the big 3 while they install the amp.. do any electricians here know how hard it is to get a new power supply for an amp like that?

Random question.. if i am going to amp these speakers.. How hard is it to get a power supply put in an amp? I have a broken Memphis mc3004 (which i was given, and told was an awesome 4 channel amp) and all that is wrong with it is a ****** power supply.. if thats cheaper than a new amp, problem...

Hmm even more good advice.. first address: 400 isnt a lot, you are right, but Im not looking to destroy the block with my bass;) honestly i feel my sub already destroys the low end bass.. I feel like im lacking a lot of mids though.. anything ~60hz up starts fading pretty quick i believe...

Don't think i have the room to properly run a 15 in the trunk, but i wouldn't be ashamed to run some skar 8's or 10's.. also, my amps birthsheet is 1017 rms, so if ima up an amp i want like.. 2krms;) however id have to get a new battery and maybe an alt.. I love my sub, but want something...

Well its only the HU that i 99% will not change.. Just because i got it as a gift, and is part of the car now, gives it character:) Amping front and back stage is a VERY good possibility, downside is i can't install myself.. But even with the stuff i would change, what route might people take...

Read title. Here's what i have: HU: random alpine one. NOT CHANGING Front stage: 3.5in kenwood speakers. No amp Back stage: Alpine type S 6x9's. No amp Sub Stage: Custom built TC7 12(i believe its the 7, 1krms) with a Massive Audio N2 amp. Battery/alt: stock, probably will not change ...

at the moment so would i!

SPL i know youve done 8's.. you ever dabble into 6.5's or some midbass drivers?

i have 1 of these exact subs.. idk where they came from, (i heard arizona?) but they are sick.. lucky of you to have 4;) Look forward to vids!

I think its at 3.5 at the moment, will 3" give it maximum output while still kinda maintaining control? I dont want it to sound like ***, but id much rather have it be loud at the moment than crystal clear

I have an N2 and it runs over rated.. says 800@1 ohm but it was measured puttin out 1017 at 1.. id say the n4 is probably pretty nice too! (as well as being insanely small for the power they put out!) they are extremely similar to elf audio i've heard.. id get him down on the price a little...

Just tryin to figure out if the port area is going to F**K up my sub on notes lower than 30hz or not before i build the box tomorrow. I think thats 18.5in^2 per ft^3? will that be alright for a decent peak around 34hz as well as get the lows pretty decent? (box is ending up tuned to 34hz on the...