Recent content by xgallegos4

So wat would be the best choice add an isolator or wire the batterys in parallel I'm running 2batts one under the hood one in the trunk

I got a question I going to have at max 4.5k watts and I was told to add the extra battery but iheard I should run a positive and a neggtive from the from to back and then add a battery isolator. But then I also heard I could just do the positive run from front to back and ground the battery in...

4sho but which is better?

is Kolossus Fleks Kable ofc? and is it real 0 gauge wire? Kolossus Fleks Kable or stinger 0 gauge flex wire?

so i want to do the big three in 0 gauge on my 2001 impala but i have a few questions do i remove the wires that are already there then attach the 0 gauge? or do you leave them there and add on top of them? also has anyone on here done a big three on a 2001-05 impala ?

ok then who sells the audiopipe3000d ? because i might as well spend a little more for a better quality amp

so its a good amp or should i go with this one? Power Acoustik OVN1-5500D 299.99 or the alpine Alpine MRP-M2000 419.99 ???

is this a good amp or wat Alpine MRP-M2000 im looking for a 2k- 3k rms amp at 2 ohm stable

so there really 4 ohm speakers?

shipping to 95304

my buddy bought these cheap subs but wants me to connect them but im not sure how because on the magnet it says 3.2+3.2 ohms how do i wire these in a bandpass box? Eclipse SW4010 he has a 1000 watt amp 2 ch

ok so you guys are telling me i should of got the 4 ohms in stead of the 2 ohms? and whys that? im a lil new to the car audio. and i changed my mind i want to run atleast 3k rms in total so what good amps are out there on a 500 budget? im going to be running these subs at 2 ohms total load.

ok so i need to pull out all my 4gauge and put 0 gauge in stead? ill have a dist block from 0 gauge to 4 gauge for my 500 watt amp then 0 gauge for my bass amp. and ur telling me i need a battery in my trunk so in total i would have 2 runs of 0 gauge from my hood to my trunk? and what battery...

ok so i have a 500 watt amp ran with 4 gauge now i want to add a bass amp with about 3-4k rms so should i just take out my run of 4 gauge and replace it with 0 gauge or is there a way to add the amp with out doing that because i dont want to waste wire. my other question is will i need to add...

so the only way to wire them in 1 ohm would be to get an amp for each sub?