Recent content by x3ro

I'm a retard and left the card and reader at work again Will be sure to grab tomorrow and take pics.

bump.. will have pics this evening when I get my memory card

No worries, will do

*found local buyer*

replied back my man

looking to pick up an iphone 3g.. let me know what you have... could also trade my at&t tilt + some cash if you wanna trade.

I have an 8925 in good condition... Has a couple scratches on the back, and could use a new back plate, but it works great and it's flashed with WM6.1 with Manila 2d interface that I might be willing to part with.. I'm looking to pick up an iphone 3g. What are you looking to spend? Shoot me...

Bump.... Still looking for a 9887!

The body being welded to the frame thing is only true if the car has a unibody support structure. If it's an older car, or a truck where it has a true separate chassis, the body would not be welded to the frame.

Bump

Uh.. No.

Therein lies the problem. I haven't found a decently looking fused d-block that can do both 0g and 4g outputs, at least one that can use ANL fuses @ 200A... knukonceptz has one that can do a 1/0g or 4g, but it only uses the mini-anl wafer type fuses.. Any ideas on what to do? I figured the...

I'm not new to car audio, but I have a question on some wiring.. I'll be installing two amps, one around 2000wrms and one around 400wrms for highs/mids.. The 2000wrms has no internal fuses, and recommends 200A for fusing. the smaller amp has internal fuses, and recommends 80A for fusing...

Looking to pick up an Alpine 9887.. Let me know what you have!

I'm planning on picking up an Alpine 9887 for a HU just FYI.. I keep hearing everyone talk about "going active." I'm aware that means powering the tweeters and mids in a component set independently and using some other EQ or HU to cross them over rather than the included crossovers ( that come...