Recent content by wotan

I know this thread is a little old but I wanted to chime in and say that I run a p900.4 and a p600.2 in my boat. I push them hard at 2.5ohms in an unventilated environment and I've never had a problem. Previously I had some old school kicker A/B amps in there that would get to egg-frying...

Hah! They are all 4 ohm speakers.... Since all 6 are going to be in one location is it important that they all get the same amount of power or is that not going to be an issue?

Trying to wire the tower speakers on my boat into a 4-channel amp.... Previously I only had 4 speakers and I was running them at 2-ohms in bridged stereo mode... Now I'm upgrading to 6 and I don't think my amp is going to be overjoyed to be running at 1.33ohms, right?? Help!

Hey guys -- Just bought a refurbed BRUTUS BX2200D from sonicelectronix and I'm trying to hook it up. Unplugged my old amp and plugged this one in and with only + and - and remote hooked up it goes straight into protection mode. 2g runs about 3 feet to a fused distro block and then grounds...

I already have 4x12s so bass isn't really an issue in this setup.... I just expected that my mids would be capable of more.

Amp is running off 3 newer optima blue-tops that are maintained on a 3-bank charger/maintainer that is plugged in whenever the boat is not in use. There is also a 160amp alternator and I see typical idle voltage right around 14volts. Though the amp may not be tuned "perfectly" I have every...

Isn't the MA Audio stuff mostly bottom feeder? I mean.... I can pick up MA Audio speakers on ebay for ~$40/set. Is this the greatest value out there or has Kicker fallen that low?

Hey ya'll... I'm looking for some feedback here. I bought a boat with MA Audio throughout about 7 years ago. It had 4x12" running off their big-dog amp (~4000watts advertised) and then a 4-channel (4x150 iirc) running Ma Audio 6.5" component speakers. Over time the speakers have gotten wet...