Recent content by vroomy

Some shop i was chatting to .......

Yes i realise they are totally different subs, thats why im asking which will work better in my situation? Which will get louder and deeper with sealed box and power on hand? Or is there a better option? I have the dc sitting but was told the jl will work better, but im open to more recommendations

anyone had experience with either of these drivers? im prob looking at sealed enclosure because of space unfortunately. I have 2 DC lvl3 10's and can give them the .65 they recommend or would i get better output from 3 JL tw3 10's in .5 per sub? i have a t1000bd rockford amp to run them. Also am...

Hey guys, so my system is slowly coming together. I have a DD M4 running 3 DC Audio L3 10's and now looking to decide on front stage setup, hoping to get a few opinions. My options are, i have 2 sets of old school Orion HCCA 6's or a set of A/D/S 246is that i can run with a pair of CDT qes-680...

Very interested. Sent you a pm

Hi looking for a black ppi 404.2 amp. Prefer in real nice condition. Have paypal etc. Very keen to buy asap

Makes me want to stay with my ppi haha

Thats a very cool brochure indeed

So update. Im thinking of switching to a zapco c2k 6.0, specs say ok at 2ohm bridged for 1200watts. Good move or bad? Not familiar with zapco. Are they as good as ppi?

2ohm mono?! Wont it blow up at that impedance?

So what happened is i managed to swap my power hx2 15 with a friends t1d415 which works alot better in a smaller box going by rockford recommendations. Prob is i have this A1200 with a sub at either 2 or 8ohm load. Am trying to avoid spending excess money

Thanks for the manual link i already have that, but it has no power figures for bridged into 8ohm

Any ppi gurus here can tell me what the true ouput of an A1200.2 art series amp is when bridged mono into 8ohms?? I know if we go the rule of thumb it should be half the output at 4ohms which would be 600w, but wondering in a real world test is it any better?

Im just trying to make this work because i have this driver and id have to spend money to get anything else. What size port area do i need for a 15? And how is that determined? Whether or not this sub will work im interested in this info

Yeah that does sound the easiest route. But i did download that box calculator and have punched some numbers. Now the spec sheet says 3.5cube box with 4 4" ports at 18" long tuned to 33hz, i came up with a 3.55 box with a square port 4"x5" and 10" long which tunes to 33.3hz.......will it work or...