Recent content by vinsewah

hmm, i just replaced the tweeter and i still get the buzzing! could it be a bad deck or an amp? could it be bad wiring? any ideas?

Thanks for confirming my suspicions. I was hoping it wasn't a problem with the recording source, because most of my mp3s played at a reasonable volume give off that buzz. I'm hoping its not a wiring issue as it would be a major PITA to fix. The mid's AFAIK don't give off that buzz, only the...

Rear speakers don't buzz. So its kind of weird, for some songs the buzz isn't as bad but for others it is pretty bad. Could it have something to do with the quality of the recording?

So I have a problem with my tweeters and thought I'd seek the experts on this forum for help. My tweeters buzz whenever I play music at almost any volume. It doesn't seem to be the alternator whine because the buzz happens with every distinct sound played through the speaker. For example, a...

True, however I get the feeling that once they've received my money they have no incentive or need to be as helpful as my fellow forum members...

http://vault.alpine-usa.com/products/documents/PDX-4.100%20OM.PDF Are you talking about item 8/14? Where is the switch you're talking about...

Bump!

Can you elaborate on that plz? Currently the dial is set at the middle mark for both front/rear speakers. The gain for the 2 channel is cranked up 3/4 of the way since I can't hear anything from the subwoofer...

I have a pair of Alpine Type R's in the back for rear fill and I've discovered whenever I play music at high volumes I get weird buzzing sounds. At low volumes the buzzing stops (or maybe they're too faint to be heard). So are my speakers jacked? I just got them less than a month ago...

Bump!

I drive a Honda Civic 2008 and recently upgraded my system with a new HU, a pair of component speakers in the front, coaxials in the rear and a sub. The problem is, I am severely lacking in midbass and it sounds like I don't have a sub at all unless I crank the volume up to the max. Here is what...

I bought a JL 10W3v3 sealed powerwedge and originally thought 300 rms would be good enough to power this bad boy. After all, it that is what JL recommends on its website. The dealer I ordered this sub from said 300 rms should be fine and I shouldn't encounter any problems with. But then when I...

humpty bumpty

So here are the prices for each: 9886 - 220 9887 - 300 700BT - 235 I'd still like a comparison between the 9886 and 700BT. I just think the 9887 would be a waste if I'm not going active.

Ooh. You're right! Ok so my concern is that I'm not getting enough mids and my highs are too loud. How would I go about adjusting the EQ for that?