Recent content by TWhitesideLL07

So how much polyfill would i need to put in my box? and where do i get it?

If i added polyfill to my 1.22 cu ft sealed box, would i make my SL-p sound louder? I understand that it would make the box seem bigger by slowing down the sound wave but does that make it louder, does it decrease the SQ?

I have two Rl-p's and i noticed that the metal cone gets hot (guessing from the voice coil)....and today it got too hot to touch and this was after a 10 min ride. (was about a 100 degrees today). Does this mean i am putting too much power into them causing them to heat up??

ok thanks ...sry about the bumping i needed to kno before i went to bed so i could return the tee nuts

bump

Today i built my box (MDF) for my two Soundsplinter RL-p's.(letting it cure for a day) When i go back tomorrow to bolt the subs in should i use tee nuts or not...the subs r pretty heavy (35 pounds)

ok thanks man

In a sealed box for dual subs do the chambers need to be separate? Does it make a difference if the chambers are separated or not?

will a steel box sound better than a wood?

ok i was just wondering b/c i was reading around today and some ppl said to have a 250a-300a fuse and i was crap.

bump

Today i put in my H/O alt. (205a) and did the "big 3" with 1/0 wire i ran 1/0 from pos on alt to pos on battery...then ran ground from neg on battery to chassy and then ran another ground from neg battery to engine... Does that sound right?? And also i put in my new fuse for my new amp and i...

http://www.soundsplinter.com/rlp_series/12_inch_subwoofer_enclosure_recommendations.html see if that helps

I was just wondering b/c its a more powerful amp than my 600 watt amp for my door speakers and the remote turn on wire is REALLY small and it works fine

So i dont need to run 12 ga for remote turn on...then what size do i need to run??? And someone explain the big 3 to me plz