Recent content by Trender372

Anyone?

Have a 2001 Mustang coupe that I deadened the trunk with dynamat (there was a lot left over from a friend's install, so don't flame ). When it was being put back together, right under the rear deck there are pieces of factory plastic/fiberglass (whatever material it is) that won't go back into...

Got a buddy of mine that went down to Parts Express today because one of the installers at Best Buy recc. he get these: http://www.crutchfield.com/S-VmIityA5JsK/cgi-bin/ProdView.asp?g=762&tab=essential_info&i=237XT65#Tab For starters, he has some Germaniums, and the installer told him...

I have noticed sometimes that on Monster Cable when you strip it, there is.. almost like another layer of material surrounding the wire and you have to re-strip it again in hopes to get it off. It's a pain in the butt. I'm assuming that was what you were referring to (the clear material on the...

Here is (more than likely) a rather n00bish question so please forgive me. My vehicle came with wire already ran for the mids and highs from a previous install. New wire was ran because it had the mach 460 sound system. As I have taken the door's apart, etc, I have noticed that whomever ran the...

Ok, well I'm becoming more confused. I have two of these subs because I was eventually going to get a 1ohm stable amp to run them, but in the meantime I was going to hook one up to my Kicker 1000.1 I got the other sub out, and here is exactly what I did. I tested VC2+ and VC2- together, and...

I took all wires out and tested both pos/neg together for each set (VC1+VC1-, etc)and one set read 4ohm, the other didn't read at all. So I guess it sounds like a coil is fried. Right out of the box, too >.

Yes, I have connected the two positive coils, and then ran a single wire to positive on the box. I did the same thing with negative, and ran that to the negative on the box. Tested it with my meter and it still reads 4ohm. I tested my friend's CVX's earlier and it read 2ohm, so I dont know why...

Hello. I had a quick question. I have a 10" Alpine Type X sub, 4ohm DVC... and I was trying to wire it at 2ohm to run it off my amp. I was using this diagram.. However, when I wire it like this and connect it to the back of the box it still tests 4ohm with my meter. I know that these subs...

I did a few post searches and couldn't find an answer. I just recently bought this deck, and Eclipse's customer support wasn't helpful is answering my questions. I'm hoping someone can help. 1. How do you switch from 4 speaker to 3 way speaker layout? When I go into sound adjustment mode and...