Recent content by tramont

Thanks I'll solder on a new one and give it a try hopefully it works I'll let you know

I tried lineout 2 and get no output from it So thats when i took my amp apart and found that there was some bad solder on rca joints.

I have a 0 Gauge Fused power wire running to a distrubution block then 2 4 gauge wire outputs going to my amp.

It was one strand of my 0 gauge wire

You guys EVERYONE MAKES MISTAKES how else would we learn?

I just wanted to know could that be the culprit? How would I go I about testing the ics of the circuit?

I have a kenwood kac m3004 and when I was trying to adjust some wires my power and ground kept rouching because of a stray wire now only one rca plays. I took it part and found a blown 22uf capcitor also

yea you do have a point there

With the wires im intercepting now I think thats what its doing on a wiring diagram i looked at the wires i tapped into are coming from the bose amp and the are controlling the whole left and right channels. also here is the link again and a picture of what im doing [HOW-TO] AUX (Line-in) on CTS...

Yea it would be but I heard the audio is terrible

What I did was get 2 relays one for the right and left channel and put them on a circuit board. Then what i did was cut my radio wire harness, connect the wires coming from the speakers to one side of the relay and the wires coming from the radio I connected those to the other side of my relays...

What I did was get 2 relays one for the right and left channel and put them on a circuit board. Then what i did was cut my radio wire harness, connect the wires coming from the speakers to one side of the relay and the wires coming from the radio I connected those to the other side of my relays...

Im trying to add a aux to my factory 03' cts bose head unit. I tried doing this diy i found on cadillacforums. com its called How to aux (line-in) on cts without sat radio. I did this but my only problem is that when I flip the switch there isnt audio coming from my speakers when i plug in my...