Recent content by TMills

ok i probably wont get any crossovers because i didnt do my install and i dont wanna pull my dash out again. but yeah the speaker connected to the head unit. how can i find out what the max volume can be played on the car speakers? is it the same way as tuning the sub by paying the 40hz tone...

Nope no HPF my gf bought me the HU so I can't be mad she didn't look into that. Should I leave the subwoofer setting on the HU at 0 too or +8 to overpower the speakers or it really doesn't matter?

Ok so basically start at HU and play 40Hz on speakers to see where I hear distortion. Then back down. That is the max volume I can have my speakers at. Should I have sub setting on head unit zeroed out? I wanna leave room to adjust it if songs come on with light bass or heavy bass I could turn...

I guess you could say they aren't technically mids but I can hear 40-55 hz crystal clear and "loud" but when a track seems to get around a 60-100hz bass it really seems non existent.

Ok so put sub w setting on HU @ 0, mids @ 0, bass @ 0 and treble @ 0 and it will be equally as loud?? It doesn't seem like it, I have an 03 impala and my stocks speakers are super low on the kick panel. I put gain lower on amp to put bass boost in w/o the 40hz clipping. I thought it would be the...

I just set the gain by ear on my amp but im missing alot of mids in songs (using a 40Hz tone i listened for clipping) . i had bass boost down all the way down and low pass all the way up to 200Hz to check for issues when tuning. I have a JL audio JX500/1D amp and JL CP112-W0v3. I have a KWR 710...

I just set the gain by ear on my amp but im missing a lot of mids in songs (using a 40Hz tone i listened for clipping) . i had bass boost down all the way down and low pass all the way up to 200Hz to check for issues when tuning. I have a JL audio JX500/1D amp and JL CP112-W0v3. The JVC KWR 710...

sure. i just took a look on crutchfield for the specs of the HU. heres what some of the specs say and forgive me for being a beginner but i barely understand any of this, but im trying to learn. 2.5V/4CH Preamp Output: two pair of 2.5V preamp outputs (Front, Rear/SW). You can set the Rear/SW...

well i mean it sounds like a stock system if not worse on flat. its like there is no bass at all.

Hey guys, im new to the first post here. Im new to the forum and I just got a JL Audio CP112-W0v3 12" slot ported box and a JL Audio JX500/1D amp. The guy that installed it told me to leave the EQ on the headunit at flat. but quite frankly it sounds like factory. I didnt pay $700 for factory and...