Recent content by svolach

bump... anyone?

Ok, so what I ended up making was this: 2.25 at 32hz. It is f'n loud, however the sound quality is shit.. Its too boomy, and all over the place. Its not tight like i wanted it to be. I have a Avic N1 with a parametric equalizer and crossover built in.. plus the crossover on the RF P4004 amp so...

so all of you guys recommend a bigger then the recommended 1.7 box? It won't be distorted and too boomy? I'm just used to usually going by the manufacturers recommendations for stuff like this.

Hmm.. 2.5.. that'll turn out to be kind of a big box, its goin in a Acura Legend sedan, and hte trunk is pretty small .. but i guess i can live wiht it. also.. ive heard its good to put eggcrate foam around the interior of hte box to eliminate standing waves. Would you guys recommend it?

Ok guys, I have a 06 12" Type R 4ohm that I want to put in a ported box. The manual for the sub says 1.7cubes at 33 or 34hz i think. Should I go by that or is there any better dimensions for the box? Keep in mind I will be powering this with a Rockford P4004 its rated at 200Wx2 @ 4ohm however...

Hey guys I have the avic n1 with the original software. I want to upgrade the software, mainly for the map. I know if I upgrade it to the N2 software you can still bypass the lockout, but what if I upgrade it to the N3 software? I need to have it bypassed cuz I have an xbox witha 250gb fro all...

Hmm.. yea true about the single box, but I would still prefer having it custom fitted.. any ideas for ported? O.. and im sure its been discussed but, whats a good optimal enclosure size and tuned at what frequency (considering I will just build a regular box?) Ive searched the site already, but...

Hey guys, I'm thinking of making a custom fitted box for a singe 12" type r. I want to make it a ported box. The problem is thou the box wont be a standard, cube or rectangle. Take a look at the trunk. I need the box to be set back as much as possible so it does not interfere with access to the...

Hey guys, I'm thinking of making a custom fitted box for a singe 12" type r. I want to make it a ported box. The problem is thou the box wont be a standard, cube or rectangle. Take a look at the trunk. I need the box to be set back as much as possible so it does not interfere with access to the...