Recent content by surreal89

I have a DSP. 32 bands for each speaker. Maybe I can try to solve the problems this way?... I would say to concentrate between 1000 Hz and 5000.

the time alignment has already been done. anyway you were right!..I listened with the windows down and the improvement was truly remarkable!.. the midranges expanded and blended with the woofers perfectly.. the sub seems to sound much more in phase with the front. it feels like listening in high...

I guess I have to equalize the mids right?.. since they work in the most critical range

I have a 3 way system... despite having adjusted the levels of all the speakers, the problem remains that the highs are sometimes a little annoying. I would like to know what is the range of frequencies that can usually bother the ear. 2000/4000Hz? my mids were set to 4600 Hz while the tweeters...

good morning, after having set the cuts of the sub and the woofers I wanted to understand how to calibrate the phase to make the subwoofer play on the dashboard. I have a measurement microphone. My DSP only allows you to set two modes for phase, 0 or 180... while the amplifier allows me to set...

thanks for the reply. in fact the tweeters are connected to a two channel, and I send them 65wrms in 4 ohms per channel. the gain has been calibrated with smd and also the levels are further lowered by the dsp since I brought them to 75db during the level calibration. so everything should sound...

so you advise me not to go below 3000 hz with the tweeter? I thought I was safe having set them at 2500hz 24db. of course they are carefully calibrated for a sq system

The woofer is mounted in the port with full treatment. The tweeter is placed on the upright at eye level, and both tweeters face the listener. I have adjusted the levels and set the time delays...

I was thinking of setting the mid-woofers at 2000 and the tweeters at 2500...since these tweeters of mine can go down a lot, I would like to use them.

The woofer is mounted in the port with full treatment. The tweeter is placed on the upright at eye level, and both tweeters face the listener. I have adjusted the levels and set the time delays. But unfortunately I cannot figure out, without a measuring microphone, how to mix them. Woofer...

Reading the first comment, I almost thought there were only negative consequences. In my case, my subwoofer is intended for sound quality. the box is a 50 liter. so in this case can i remove the ssf set to 33hz 18db? what are the improvements i get by removing the ssf?

Good evening,wanting to get a sound with more control and less turbulence I decided to close the reflex port of my sub. What aspect of the sound can such a situation affect? The phase? The crossovers? The time delays? My sub with open reflex port was crossed with the woofers ( 60hz sub and 70hz...

Good morning, I have a small doubt regarding the pendency. As a source I use a DAC... using my phone with OTG cable and optical output. Having done this I completely excluded the car radio, and with it all the controls, equalization,cut and finally I can work solely from the DSP. What I didn't...