Recent content by strawhat

ok so im going to make a box cause i might be getting another sub and my box is utter poop damaged from my car accident. so i would have to of these subs, 10" Champion Series Car Subwoofer Peak: 1000 watts RMS: 200 watts Impedance: 4 Ohms Sensitivity: 95 dB Frequency Response: 20-180 Hz...

so do you think i need to upgrade my amp? cause im going to go get the 8 gauge wire but when i have it at min and turn the bass up on my stero it distortes my door speakers. any sugustions?

heres all the specs i pulled of the site, 10" Champion Series Car Subwoofer Peak: 1000 watts RMS: 200 watts Impedance: 4 Ohms Sensitivity: 95 dB Frequency Response: 20-180 Hz Single Voice Coil Injection-molded polypropylene and paper composite cone Urethane surround Double cone design...

the amp can handle this, Audio System Sound Output Mode Stereo Response Bandwidth 5 - 50000 Hz Signal-To-Noise Ratio 100.0 dB Max Output Power / Channel Qty 200 Watts x 2 Continuous Power / Channel Qty 100 Watts x 2 Input Channel Qty 2.0 Output Channel Qty 2.0 High Level Inputs Yes...

ok so i need to get 8 Gauge wire for my ground turn the the filter to LPF and sensitivity what should i set it to by label on my amp im not that fermiliar with what you said to turn it down too.

ok so im using my kenwood 600watt amp to power my 1000watt pioneer sub, its bridged, im using 12gauge wire for the speakers and ground. so its really hot so i know its not set right so what settings should i use. and should i use the cap i have? heres some pictures what its looks like the...

then what could i do to wire them into my car?

wy would it sound like poop lol and i already bought speakers that fit the front i bought a pair of xploads 6-1/2IN 4ways

ok so i have a spair set of boss 6530's that didnt fit my front door for some reason. so i was wondering if i could do this, i was going to make a custom box and have the two speakers on eather side of my sub and connect the speakers to my amp as i have a 2 channel 600watt kenwood amp so i was...