Recent content by SQ is the SQUAD

this is a screenshot from my manual

i was playing with my unit somemore and i figured out that both black wires might not be grounds. the picture in the installation manual shows one of the black wires connection to a little box on the yellow wire. my original yellow wire was yanked out and replaced with some clean speaker wire...

so heres my story. i brought this pioneer tv off ebay thinknig it was a brainless unit like my buddies. it seemed pretty new and it looked like it had all the wirinbg ect. i belive this was a return or something. someone nessed up the acc wire on the rear plug and it was fixed. i wired up the...

ok

in that case ill prob use seperate grounds, do you know about that ground loop thing i was talking about with the small wire (renote size) going from the raido ground to the amp ground

i have a couple of questions on this unit i know it is fairly new, i want to get this unbti to run sound, but i am also going to get a pioneer 7 inch wide screen indash (prob 7300dvd). my first question is, with alot of bass, is this unit likely to skip or not work or does it have good skip...

good looking out. ill go pick up 17ft of zero guage and use the 4ga from the block to all the amps. as for the grounds. should i ground each amp to the frame or is a dist block for ground good enough? lastly, one of the less reputable 12v associates at my job told me to eliminate ground noise...

even if i ran 0/1 from the battery to the rear and used a dist block and ran 4 ga to the amps will this still be bad, i just dont want to waste all this 4ga

i had brought this tsunimi 4ga amp kit from circuit city but now i have change what i am going to run for the system. since the kit has already been installed into my car, it cannot be returned. i am going to be running 2 kicker 1200.1 and a kicker 350.4 the 1200.1 will be pushing o4s15l7 and...

i also just finished my box, but it dident come out that good. i dident have those 90* clamps and i was putting it together bymyself. i really made a big mess. i am going to to buy some of those clamps cuz i still have a whole nother sheet of mdf so i can make a second box. plus i used a crappy...

and what is everyone opininon on filling the box with the cotton ploy stuff

i might just splurge the $10 to have you design the box, eventhout i am almost there. i am just not sure how about making the slotted port. anyways let me looking into it a lil more and ill get back to you. thanks alot for all the help, its really appreciated

here are my new calculations after a million searches h=16" w=36" d=20" 3/4 mdf 2 4" ports @9" long 5.36 CF before 4.65 CF after port tuning hertz = 33 port area in square inches = 25.13 am i getting closser still trying to find the suggested Cf for a ported 2 15l7 enclosure

just the thread i was lookibng for (thanks search button) i am trying to get my measurement together to start building my box, i planed on screwing the box together with gorilla glue in the seems then using some resin over to get all the seems pretty hard. so i take it that i dont have to use...

when you resin the insode of a box to you resin just the seems or the entire box?