Recent content by speng

any luck with fixing ur amp matey

Yes, thank you. Im a bit of a perfectionist and try and do things until Im 100% satisfied. Do it properly 1st time is what I try to do at all times in anything. For the subs, Im using a crunch gp3000d and it pounds. I think The amp is great but I also know that better subs would slam BETTER...

thank you for the comment;)

I just thought that the higher the tuning, the less the lower notes would drop compared to tuning it low if that makes sence:rolleyes: I probably should have gone 32hz minimum but Ima just leave it now as it was a headache getting the box in, in the 1st place but it does wobble the s*** outa...

I finally got round to testing the box out in the car and this is my opinion. It plays the lows extremely well, goes deep and drops deep no doubt but I'm missing the high notes. It seems to play all low notes very well but higher notes are lacking, Its seems like a one note box but I have to...

Thank you. I will have a look over everything and get it sorted. G:)reat explanation:)

Thanx, I will give it a go. I aslo have a active crossover and dsp upfront, I will check the grounds up there to. I know my amp grounds are good because they are running direct to the 2nd battery in the boot and the runs are short. Its only happens when the bass amp is connected

how do I solve this please, what do I do

Im running 3 amps, when I disconnect the bass amp, the whining disappears when the engine is runining from the mids and the tweeters which are also run on separate amps, (active system). when I connect the bass amp back up, the wining comes back through the speakers. Any ideas as to why this is...

so far so good. I hope this box is a propper dropper and plays deep and loud :raz::raz::raz:

Well I finished the box build and here are the PICS. Just threw some carpet on it but it wasn't the best carpet but I wont be fussed this time round I have not played it yet but will very shortly

Im just about to cut the holes for my box and have measured that they are 2inches apart like this for example 0--0 Is this ok or would I have a problem this way ?

Yep, will do. Thanx again for helping out a newb bro. Appreciated and to every1 else :veryhapp:

heres some pics. Just need to cut the holes for subs, drop the top on and carpet the box and seal up a few more areas then its good to go. Here is a pic of the old port length I was going to use tuned to 29.5hz or so and the new port length Look how long that port is. YERRRR (if thats...

OOHH, lol, Its a slot port and I would have a bit of a problem removing it as its all glued down and screwed. Anyway, I like bass very rumbly, deep and wobbly beat line where you can feel it hard and where everything flexes. I could trim the length of the port down but with a hacksaw but dont I...