Recent content by Shawnlh

Amp is a Zapco DC1100.1, I'd like to stay at 4 ohms.

I did some math, and the internal volume is .714 Cu' for each sub. Of course subtracting speaker displacement, it seems that an average is about .05-.125cu'. So it seems that after speaker displacement I'll be left with .58-.66 cu'. Again depending on the speaker displacement. Mounting depth...

I have an '03 Dakota ext. cab. Using the following, Eclipse h/u, zapco dc amps, dynaudio comps, but I am having a difficult time choosing subs. My space is limited as the box HAS to fit under the rear seat. I found a box design from another audio enthusiast that was kind enough to share it...

(Rear speakers should never be allowed to operate in full range unless you are going for the THX or Dolby Digital AC-3 theater surround sound setup. If you have a separate subwoofer, band-limit the signal going to the rear speakers to approximately between 200Hz and 3kHz. To wring out some...

Ok, I'm going to have to go with the MTX Thunderform for my '03 Dakota ext. cab. (link...http://www.mtx.com/caraudio/products/manualsQuickInstall/thunderforms/DDXP201_specs.pdf) I have narrowed the sub choices down to two. 1-IDQ10D4V.2 2-JL10W1v2 What do you think, or better yet, what have...

Hi guys, I'm in need of some assistance. I'm going to try and build my first SQ system, it's going in a '03 Dakota ext. cab. It's not for competitions, just personal use. I am intersted in obtaining the best possible imaging I can within my limited budget and speaker placement. I need to stick...

I need new subs, my box holds 2 12" and has a total of 5.99 cubes, and is tuned to 36hz. I want Rockfords because that's what I have ran for the last 5 years (HE2's) But with my power supply (Memphis st1000d) I don't know if I should go with P3's or T1's? Thanks for your help Shawn

Could you rephrase that please, I'm not sure what you're saying here . I need a simple explanation. For example ( 21"x48"x24" with 4"x11" ports)

I have a a pair of older (2001-2002, I think) 12" He2 subs and I want to get the best out of them. I'm using a Memphis ST-1000d amp to run them. Box size can be whatever as I have alot of room. I do want to port the box if you could include that as well. And, should the subs be separated in the...

I'm looking for a good used set of Rockford Fosgate FNQ 2614 components, please reply to slheinz@shaw.ca , Thanks.

I need a new set of 6.5" componenets and I've narrowed it down to Rockford FNQ2614's or CDT CL-61A's. Your educated opinions will be appreciated, Thanks.

Ok, a sealed box, but how many cubes per sub? Do I need any insulation in the box? If so how much? Do I need to keep the subs separate in the box, meaning, do I need a partition in the box. One more thing, can a sub in a sealed box handle more power than in a ported box??

I have a Memphis st1000d amp, and two 12" rockford he2 dual voice coil subs. I will be running the subs at 2 ohms. I listen "mostly" to rock (ac/dc, saga, queensryche, ect.) but do enjoy some electronic music (delerium, enigma, ect.) I have enough room for a 6 cubic foot box. I do like it when...