Recent content by rolloutjg

i like the idea of the distribution block, that makes for nice clean connections right? alot better than twisting the wires together? i see what ur saying about using 4 separate wires per sub.. but what if i did this.. (notice the distro block i added) good idea or no difference really...

ive got two JL 10w6v2-d4's and i wanna wire them up to 1 ohm.. is this right?? sorry for the bad art haha

noo.. i know how to wire it to 1 ohm, but my question is whats the best way to splice the wires? i would imagine just twisting them together or stuffing two or 3 wires together in a terminal with no real hold is not a good idea..

ive got two JL 10w6v2's rated at 600 watts rms.. should i get a rockford fosgate 1000 watt amp, or a 1500 watt amp and just keep the gain down?? would it even make much of a difference?

so you have 3 wires meeting together in one terminal? sounds kinda sketchy

ok i know this is a newb question, but ive never wired my subs to 1 ohm before... but, where the boxes are, how do you properly splice that so you dont lose resonance?

thats the exact same link i posted earlier. and all i was wondering was if the subs could handle that amp at 1 ohm

yeah, im definitely leaning towards the T1000-1bd.. i think it would fit perfect where im trying to put it.

ok sounds good, looks like ill wire them to 1 ohm. so now i just need to find an amp.. i hear what your saying about 1 big amp being better than two, but the only 1000 amps i can find are mono the T1000-1bd looks good.. it says "It can easily drive four 2-ohm DVC woofers without breaking a...

also, if i got an bass knob.. is it possible to use one knob for two separate amps? Amazon.com: Rockford Fosgate Punch PEQ Equalization Remote: Electronics

Ive got two JL 10w6v2-d4's on the way, and im trying to figure out what amp to get and how to wire them. JL's site wasnt specific to each sub, but it showed how to wire to 1 ohm.. 2 DVC drivers with Voice Coils in Parallel / Parallel: Dual-4 Ohm Subwoofers: 1 Ohm JL Audio - Car Audio Systems...

i have an 06 f150 screw, anyone know a place in socal or online that can make a custom enclosure for 2 JL 10w7's? its going under the back seat, and im getting the seats custom raised since the prefabbed boxes i see online only allow 5 5/8" inch clearance and the JL's require 8.25". im willing...

i have an 06 f150 lariat (supercrew).. im getting the seats raised enough to fit 2 JL's (the 10w7's require 8.25 inches of clearance) what would a good amp for that be? i want this system to be so loud it makes you throw up. i used to have 2 kicker l7's in my colorado but i had a shitty amp...