Recent content by RockyBalboa

Thanks for the input guys. Again not looking for window shaking , trunk rattling, just looking for a little more bass. I can feel the 6x9s on the seats , bass. Im running 63watts x 4 , two kicker dash 3.5s and two alpine 6x9s. Do you guys think a10" blupunkt rated at 300 rms and the taramps...

Well just came across this one also and the install would be more cleaner with this one.

what do you guys think about this set up ? About 100 dollars over my budget but figure time to make a box and sound quality over some of the underseat units this might be the way to go??? Can I piggy back power and rca off my other taramps 400x4? Still thinking its a bit much bass though.

Im going to look into this, I think just one would do me good. 8" blaupnkt.

I have a c10 chevy truck and have some what of a new vehicle factory sound in it now. I am happy with what I have but would like a little more bass. Not shaking the house windows bass just a little more added to what I have . I have limited space with the single cab and also would like to hide...

I have done the big three but its been a few years so I will go through and recheck and replace. Power for amp is direct from battery , battery only. Also my amp ground is mounted to the seat belt mount on clean metal. Also everything is soldered. I agree I will recheck and thanks for the help.

Its a 36 year old chevy truck

what filter should I look for ? Its not a humming noise but or a static type noise. All the wiring has been soldered also

thanks I will look for a supressor that will hook up to the rca. I also ran the power wire on one side of the truck and rcas on the other so that might not be the issue.

Im getting engine noise with a new amp install when the truck is running. Do I need a noise supressor at radio power input , amp power input, or at amp rca input?

can you guy help me figure out these numbers a little better? Maximum Power: @ 13.8 VDC - 2 OHMS - 400 W RMS (4 x 100W RMS) Its putting out 400x4 wired at 2 ohms. What if I use use 2 channels and not the 4 , am I getting 100x2? @ 13.8 VDC-4 OHMS - 252 W RMS (4 x 63W RMS) Im lost on this...

Thanks for the help I am going to try bridge and set it working with the volt meter.

My space is very limited in the dash , I ended up with some new kickers 3.5s(50watt RMS). The JBLs were to large to work in the dash. They hit the back of the gauge cluster and if I raised them up they would push the dash pad up to high. I think I am stuck with the kickers and also I believe the...

Can you folks look at this and tell me if this is the most efficient hook up I can achieve , with out overheating, or blowing up the speakers? I only have the two rear 6x9s hooked up the Taramps 400x4. The front dash speakers are not wired to amp . If I bridge the 6x9s will it be to much for...

eh , you guys are no fun. The module works fine. I tapped into the aux input jack. It works the same as if you plug it in from the face, only no wires visible. Works the same , just no visible wires from the face since its hooked up inside. Easy, 3 wire hook up. I didnt get all I wanted by...