Recent content by RajunCajun

Maybe I'll get a bite on this one. Can I run 2 8 ohm subs on the F450 200 watts at 4 ohms ( 100/sub) and 1 4 ohm on a bridge channel of the F450 at 100 watts?

The manual says 200 at 4 ohms but I can not find anything about the 5th channel being 2 ohm stable. I finding conflicting reports online about being stable. So with that lets say it is not. Would it be ok to run 2 8 ohm subs on one amp and 1 4 ohm sub on the other or does that cause a sound...

I'm running 3-8 ohm w1 12s which gives 2.67 ohm load can the 5th channel handle this ohm load? Also I have a 4 channel Alpine MRV-F540. If the F450 is not stable at 2.67 ohms can I bridge one channel on the F540 to power 1 sub and power the other 2 with the F450? or would this cause a sound...

Stay with the same size even if two seperate amps will be used to power the 10s and 1 12? I assumed that if I used two different amps and set the low point frequencies for each woofer size I would be ok.

I have an Xterra and was wondering what is the best method for woofer direction: firing straight up, firing down, of staright out toward the the rear hatch? I'm using 2 JL 10" w1 and 1 JL 12" w1? Thanks!

Yes at low volumes sound is horrible, but at 1/4 volume and up sounds great. Problem even exsists with motor off so I know it is not alternator noise.

I have a set of Boston Acoustics SX60 componets and the tweeters are fuzzy and crackling at low volumes. Once you get on them they clean up and sound great. I have them powered by an Alpine MRV-450 amp at 55x4 the speakers are rated at 60RMS. The head unit HPF is off and the amp HPF has been...