Recent content by QuadinExploder

that kicker ZX1500.1 is not 1.5 ohm stable, the minimum is 2ohms according to kicker. and i agree, those subs are way too nice to skimp on the amp. are they in a ported box? if so you could perhaps afford to underpower them a little, if its sealed you need to give them all they can handle. why...

thx dude, just wut i needed. wuts the difference between sine wave and tone properites version of the 50Hz (besides the Db rating)?

i tried to but the link brings me to a page that has absolutley nothing to do with car audio and i cant find the tones anywhere... the link could be a litlle more specific and less generalized i think...

i downloaded this test cd but it doesnt say how many Db's its rated at, how will that affect my reading form it? http://binkster.net/extras.shtml

nah dude i figured it out. thats y they call it an amplifier, it takes 14.4v DC and turns it into 20 30 40 and up v AC. you take your amps actual power output , mine being 1596 on the birth sheet, and multiply it by the ohms it is seeing, in my case two ohms ( two 12l72 wired in series on the...

also, i have this 50htz test cd, but i downloaded it and it doesnt say how many Db's it is... how will that affect my readings? http://binkster.net/extras.shtml

ok i read the sticky and saw the formula, maybe it was too vague for me... Volts=powerxresistance. ok so what does power mean? my amps output in watts or my HU out put in volts? i have a Kicker ZX1500.1 running two L7 12's off of two ohms, my HU is a POS sony with .4 volts coming off the...

im looking to install a couple caps in my ride, been shopping the prices online. can anyone suggest a good 1 farad cap (i wanna double up).. Kicker ZX1500.1 2 Kicker 12L7

so no one on this whole site has heard of this company? that doesnt look promising...

which lead goes where?

so i put both leads on the same (potential grounding) spot?

ok, so how many ohms shoudl i check for ??

i found one for my 93 exploder for $189, i wonder if they are any good, anyone heard of DB Electric? http://stores.channeladvisor.com/db-starter-alternator/?sck=877183

what would i be testing for with my DMM?

anyone? should i ground direct to the frame, or run a cable from the battery negative maybe ?