Recent content by Prozac

  1. P

    Here's one for all you box guys....

    If you have the ability to get a hold of a shop vac then what you could do is just pump it out that way, then take a towel to wipe up the majority left, and then use a hair dryer to finish it off. Just a thought, it would allow you to do fill the enclosure in the car, plus you could measure it...
  2. P

    how thick

    Out of all the research that I have done, most people say that it should be 7-8 layers thick or about 1/2". Hope this helps.
  3. P

    Amp suggestion

    That won't be a problem. I plan on having my girlfriend take step by step picks while I do it. (The install that is) Now, just to get the time and money!
  4. P

    Amp suggestion

    Well, once again, thanks for everyone's input. I am going to get the JBL 300.1 and the 80.4 for my fronts. I plan on getting the fiberglass and begin building my enclosure as soon as I have some time (military and Papa John's takes up a lot of my time right now). I plan on building the...
  5. P

    Amp suggestion

    No, am going to go with a sealed box. I really want to have a clean sounding enclosure and it will also allow me to fiberglass a small enough enclosure that will allow me to keep my trunk. I got the sub for less than $70 and I am going to be fiberglassing on the rear side of the trunk.
  6. P

    Amp suggestion

    Once again, thank you very much for your help. Now it is just time to save up a little bit more and get the 300.1 and the 80.4 and begin my first fiberglass install on my Grand Am. I do appreciate all the help that you have given me.
  7. P

    Amp suggestion

    It is actually a 6ohm dvc sub that I will be running in a parallel config to make better use of the 2ohm amp option. (Unless I am bass ackwards) So it can either run 3 ohm or 12 ohm.
  8. P

    Amp suggestion

    That is what I will be running it down to. Or it could go up to 12ohms. I was thinking that the 300.1 would be enough, but I just wanted to make sure. Thank you very much for your help.
  9. P

    Amp suggestion

    I have currently narrowed down my long awaited search for a mono amp to two. Either the JBL 300.1 or 600.1. It is going to power 1 JL audio W6 AE 10" that requires 300 watts rms. I am not looking to over power the sub, just get it the power it deserves. Your help would be greatly...
Top