Recent content by pmw

Has anyone owned two S8L5's and run them in the smallest recommended sealed enclosure?

OK, here is another spin. How about two square 8's (L5's) rather than one 10 with a 5" (kicker,re,ed,rockford fosgate...) or less mounting depth? Obviously more cone area, but well suited in a small sealed box and for rock and hip-hop?

I am in Augusta. So the fact that 2 8's offer a combined cone area greater than one ten means that they will be louder and deeper than one shallow mount 10 with the same wattage feeding it (them)? Even though the 8's will share the .75 cu ft volume and the 10 would own the entire volume? Is...

One of the biggest speedbumps of the sub is that I only have 5" mounting clearance to play with (after the box). I am looking at the RE's, Fosgates, JL's, and Kickers.

I have limited space and am in the process of upgrading a stock stereo system. I have a cavity for a hidden sub with about .75 cu ft. Would I get louder, deeper base from two 8's in this cavity or one 10? The box will be a sealed box. Thanks.

I have an alpine 6 channel amp putting out 60 to the rear two at 4ohms. When I bridge those two (pos left, neg right), the resistance would still be rated at 4 ohms, right? I am thinking of wiring my sub to 2 ohms and bridging channels 5 and 6. That should still be a two ohm load on the...

I have a toyota tundra with a removable rear seat support that I intend to remove and replace with a subwoofer box. Q logic makes a drop in unit that does this for two 8's. The problem I have with this is that the unit is mass produced and the cavity volume is shared. I have never been a fan of...