Recent content by pioneer_stan

Changed earth and much better thank you everyone for your help I appreciate it a lot

also my lpf is set to 80hz in subwoofer settings then my hpf for speakers are set to 100hz, does this mean 81-99hz will be missing?

also could a bad amp earth cause this low loudness? for example if it is only just enough earth for the amp to recognize it as being safe to power up but isnt a very strong connection? also my car is a hatchback so it has no boot its just open to the roof, usually in a boot the sound echoes...

Also should I use loudness setting?

I read online about slopes. The manuals are very hard to understand

What is OP mean? Sealed box

Why do they make it sound like 6.4v Is the highest? Also what slope should I have It on? -6 or -12?

Example plz with using numbers v

Also on the pioneer site it says gain of up to 6.4v why is it 6.4 lowest though and 0.2 highest?

Sla as in source level adjustment?

-6 or -12 is slope level...

ok, sounds no different to me please research it for me?   ---------- Post added at 01:39 AM ---------- Previous post was at 01:38 AM ----------   also research what 'normal gain V' is please as i want it @ 2V stock original normal max head unit

ok why 80hz? ok and its at +6 whats the other -6 / -12 one? ok cool 185w rms and 400watt max is just enough lol :P

The closest thing to sub level is subwoofer control and it had a hz rating I set it to 80hz as the amps lpf is on 80hz and that is locked to 80hz. Then it has -24 up to +6 and that was on 0 default now it hits a bit harder on +6 and another number which is only -6 or -12?

Also the box for the amp says 60w rms x2? Does that mean 120w rims bridged?