Recent content by pho4metay

Alpine mrpm850 ill check the voltage whenever this stupid blizzards is out of the way

Thanks already checked the wiring dual 4 and each reads fought 4.5. Parallel reads 2.2

No it was not new bought it on here. Any other reasoning please anyone

Thanks I might just do that but is there any other reason why my vc is buring?

Gains are half no bass boost. Ill try lowering my sub setting down but even still can't turn it higher then 10 and smell burnt smell. as of right now my two infinity sounds way louder then it does now at level 8 with the old set up. Another thing I soldered pos to pos and neg to neg just in case...

Ok just finally install my dd2512d4 and have an alpine m850. Wired To 2 ohms. Adjust the gains and so fort. Turn up the volume and start smelling the voice coil. Can't figure out why. I miss my bass. My amp says roughly 800 watts at 2 ohms should be perfect for dd2500 series.

Theres one on ebay for sale. Alpine MRP-M850 Car Amplifier (793276300850) | eBay

Drools.... Glws

Zach pm me your address

Soungs like my amp. I have the same problem

Been busy lately but sending out my amp tomorrow

quick question what would cause no output on an amp?

still waiting on the update on destined2races amp. hows that going

Its hooked up that's one of the things I checked first and my sub option is on.

Ok took out my system before I went on vacation to SD. Disconnect amp and deck cause didnt want my stuff to get stolen. Came back from vacation and hook everything back to how it was. Amp turns on but no output. Checked grounds, fuses, wiring (except rca) but rca fairly new. And I even changed...