Recent content by pablo4429

yea im nto sure exactly what idle amperage is, i just saw that somewhere so a bad ground wouldnt cause dimming too?

ok so i have a kicker 1000.1 and 350.4 bridged to two channels, so like 1300rms or so, and i ran like 15 feet of 2 or 1 gauge, it wasn't marked. both power and ground are in the same size. where would be the first place to start looking to improve, grounds? the big three? would a bad battery...

i would look into the kicker zx1000.1 they can be had pretty cheap and from what ive heard, its one of the best in build quality

yea i went and got a relay and looked up how to wire it and it doesnt seem like it will be too hard at all but thanks again all

ya i think ill do a relay since the remote is constant, thanks a lot guys that really helped

so is the remote a constant source or just a pule when it turns the amp on and pulse when it turns off??

anyone else with some opinions?

or could i just tap into the acc power from the deck becasue the fans will only be pulling likt 1 amp or so total

well the amp is 1000 rms and i just thought of something will doing this case the fans to run even when the amp is off because the power cable is a direct shot to the battery

ok so if i tap into the power on my amp will the fans like pulse with the power that the amp pulls or will the amp give too much power to the fans and blow the fuse all the time? thanks all

haha sorry but this is my first ported so I want to make sure its right... 24 wide x 18 tall x 14.5 top depth and 19 bottom depth tuned to 30 hz, volume about 2.5 after bracing and woofer, port area 33sq inches thanks a ton all, also if this is off and you can fit a box ported to 30 hz with...

he contacted me and didn't try to lowball me and payed with paypal, would do business whit again. thanks

trixter Lv = [(14630000 x R^2) / (Fb^2 x Vb)] - 1.463R *Vb = vol. in cu" **R = sq.rt. A / Pi what does Vb stand for and what does Fb stand for and how do i calc it and just to clarify R=(Area of port/Pi)^.5 if A is area of port how do I know how big to make it??? sorry for all he...

ok that is pretty off so how do i calculate how much port area I need so I can use WINISD and the sticky?

i wonder by how much?